It's Easter Break, and we at Solarbotics are shuttin' down for the weekend as of Thursday. See you Monday Morning!
Like the polite Canadians we are, we like giving thanks for various reasons or no reasons at all. So on Monday October 14 we will be giving the above mentioned thanks all day at our corresponding home bases, and therefore our office will be closed for the day. The website, however will remain open. Phone service and normal less-excessively-thankful operations will resume on Tuesday.
It's Easter Break, and we at Solarbotics are shuttin' down for the weekend as of Thursday. See you Monday Morning!
Solarbotics just attended the MakeFashion Gala here in Calgary. It was a glowing show of glowing lights and wearable technology. Check out the photos in our Flickr stream. Photo courtesy George Dimitrov Photography Among all the other wonderful things we've seen using our string LEDs before, there was nothing quite as intense as these outfits. […]
PCBGrip Cylinder Accessory (4 pack) $7.20 This accessory is great for adding standoffs and rotating elements to your PCBGrip (or Openbeam!). PCBGrip Tri Nut Accessory (pairs) $5.52 Inserting and aligning nuts into Openbeam can be a bit tricky, but this clever, simple tri-nut insert is a simple, effective solution to the problem. T-Bolt Accessory (pairs) […]
New product for your attention: Electret Microphone Breakout $7.95 Audio sensors & mics have to be amplified just right for best response. Here's a tidy unit engineered by Sparkfun to make adding an electret mic to your project easy. MEMS microphone board $9.95 Newer MEMS microphones give much better response than older style electret mics, […]
Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.
Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.