RW2i - Internal mount, and new shaft hol...

Dave Hrynkiw
May 6, 2007

We're still digging out the new inventory, and the next addition to the Solarbotics lineup is the RW2i, which is the same profile and rolling size as our very popular RW2, but is designed with a narrow hub.

We're able to do this by moving the set-screw hole inside the hub, so to cinch the screw down, you have to remove the tire from the hub, which is a pretty easy process.

We had planned to make the internal cut-out of the RW2i to allow the installation of a GM11a-14a style motor to the open side, but the manufacturing tolerance was a wee off, and we can't quite make them fit. Fortunately, it's a pretty simple process to file the edges of a GM11a-14a motor to make it fit, which has the added benefit of making the brass edges of the gearbox act as brass bushings that assist wheel alignment.

Also new to the RW2 and RW2i wheels is a new hole diameter! We've had many requests for alternate shaft sizes, so we had a limited portion of both these hubs manufactured with a 1/16" pilot hole so you can drill it out to whatever size you need!

MORE POSTS

October 22, 2002
Solarbotics at the ECRG

Well, somebody from Solarbotics will be at the Eastern Canadian Robot Games, namely Dave Hrynkiw, and Grant McKee. If you're going to be out in the Toronto region this weekend (October 26 and 27), come by and see the games at the Ontario Science Center!

February 13, 2003
K SMD Motor Driver

Got a new kit for you - the K SMD L293D Motor Driver. No, no, the SMD isn't "surface mount" - it's the Secret Motor Driver! This L293D-based motor driver fits secretly inside most standard servo cases like the Futaba S3003/S148, and our own GM4 gear motors. It replaces the low-voltage original electronics with LED-indicated, […]

November 14, 2014
Friday New Products: Microphone Accessor...

New product for your attention: Electret Microphone Breakout $7.95 Audio sensors & mics have to be amplified just right for best response. Here's a tidy unit engineered by Sparkfun to make adding an electret mic to your project easy. MEMS microphone board $9.95 Newer MEMS microphones give much better response than older style electret mics, […]

September 11, 2009
Arduino Parts and Other Things, Too

Remember the other week when we mentioned how the Arduino Parts category was looking rather thin? Well, we've gone ahead and fattened it up a bit with the following new items: 16MHz Through-Hole Crystal for Arduino Ardubot Bare PCB Barrel Power Jack 2.1mm Connection You might be wondering what the heck does a power jack […]

1 60 61 62 63 64 253
Solarbotics Ltd Logo
Solarbotics has been operating for more than 25 years, bringing electronics know-how and supplies to both the electronics professional and hobbyist. We'll be happy to help you too!

Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.

Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.

cart