So for this third hack we started with an online-bought robot costume, but being a creative tech people, we couldn't resist making it better by using some brilliant LED strips that react to sound.
The dense LEDs (144 per meter) were used on the helmet. More spaced apart (30 per meter) were used on the arms. All of them drive from one Teensy receiving analog signal from the microphone located in the helmet. The microphone captures both the voice of the wearer and ambient sounds.
Here's what it looks like reacting to the music:
Technical Build:
The idea was to attach two denser LED strips to the face mask guard and the rest to the arms of the costume. They both would react to ambient sound and light up depending on the frequency of sound. The helmet's strip would have the lower frequencies in the middle and the arms would have them start at the wrists.
The face mask guard took 52 LEDs per strip and arms got 25 LEDs per arm. These calculations are reflected in the code below.
For the arms, I divided each LED strip into two sections (since the costume itself had separate foam pieces for forearm and shoulder), and gave them their own battery. That allowed me to have a simple 2 pin connection for joining the arms to the helmet.
One problem when dealing with RGB Strips on wearables is that the solder pads are small and the wires break off too easily. I tried to minimize this by adhering a small wooden backing to the end of each strip. This acts like a cast and, when sealed with heat shrink, immobilizes the connections. I cut the supports on the laser cutter, but you can use anything. Popsicle sticks would work as well.
Here is the basic wiring diagram I used:
Wiring for Robot Costume
Software:
This code uses hardware support for FFT that's built into the Teensy. If you want to use a different processor, you will need to add a FFT library and modify the code accordingly.
I found some code online that was almost perfect for this project. Rather than reinventing the wheel, I reused that code, and modified it for my needs. Original credit has been left in the code.
Greetings, ye fine fellow travelers of yon internet. This week you'll find that we have three new and completely unrelated items to show off: 17010 3-AA Battery Holder - This three-cell holder has 9V-style snap connectors, and can create 4.5V with Alkaline batteries. 17390 Tact Switch - A push-button style switch that's compact, inexpensive and […]
Everyone is familiar with paracord bracelets - the cleverly woven wearable survival device that instantly unravels into many meters of useful and super strong nylon cord in case of necessity. These are useful for outdoorsy types, but what if you are an indoorsy type with a lot of electronic emergencies? Or a geek in need […]
We are happy to announce the arrival of the Battery Edition Marble Machine. Starting today it is available at our website for backorder, and will be fully available for purchase starting tomorrow May 16. You are probably familiar with its older cousin, the Solar Marble Machine that has a clever circuit that delivers short bursts […]
Temporary Tattoos to Monitor Vitals An lighter more wearable alternative to FitBit (Via Beautiful Decay) Laser-Cut Wood Illustrations Layering laser-cut wood taken to a whole new level, by Martin Tomsky (Via Colossal) Tiny V8 Engine Out of Paper Paper can be exceptionally sturdy, especially when strengthened by glue. By Aliaksei Zholner (Via Gizmodo) REM Detection […]
Solarbotics has been operating for more than 25 years, bringing electronics know-how and supplies to both the electronics professional and hobbyist. We'll be happy to help you too!
Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.
Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.