We are expecting some outages while we perform some upgrades. Shouldn't be longer than a few hours, starting at 8pm MST May 6.
Hey, look at us! We made a witty, over-used joke! But seriously, this week we have a schwack-load of resistors for you. Normally we save most of these for our internal use, but what's so fun about that? So we've gone ahead and opened up our entire inventory of 5% accuracy, 1/4 watt resistors. There are a lot of them. And they can now be yours, so that you too can make lame Borg jokes. Check out the full list of new resistors below. For a complete selection, be sure to check out the Resistors Category.
And one last tidbit! We've put together a Graphics & Logos section, for all sorts of Solarbotics media. There are a few small/simple website banners, as well as some larger, high res and vector logos for those of you who'd like to make something specific. You can access this page by hitting the big Resources button at the top, and then the Solarbotics Graphics & Logos link on the lower-left. So, loyal minions, venture forth and plaster our logo in all manner of extremely awesome places!
We are expecting some outages while we perform some upgrades. Shouldn't be longer than a few hours, starting at 8pm MST May 6.
From the BEAM mailing list, we're happy to report that Tom Gray managed to win 1st at the NAIT robotics challenge in Edmonton!: "Thanks again to all who endured my wails and made helpful suggestions earlier this year when I couldn't get my BS2 brained Sumovore to run. " "Grant M. of Solarbotics finally traced […]
We've churned out another Bicore Experimenter's PCB project: The "Bare Bones PhotoVore". This is an elegant little circuit, which offers the functionality of a basic photovore (with tactiles) all on a very simple circuit. Ours is solar-powered by a Miller Solarengine, but if you wanted to build one with a battery, your parts count would […]
We have expanded our selection of eSun filament to include a variety of new types and colours so you can do more with your 3D printing project. eSun Filament is known for its excellent quality, easy to store vacuum sealed packaging and easy-to-view transparent spool. eSun filament is available in both 1.75mm and 3mm thickness and comes […]
Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.
Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.