Push Pogo Pins back in stock.

Our clear breadboard was recently blogged on Makezine, which reminded me we juuuust about had an instructable ready for that same item. So, a few hours later, it is finished and posted. And while I was at it, I finished editing another Instructable by Jerome Demers, our intern. He did up a DIY Miniball instructable […]

Well, the last batch of Escap gearmotors went very fast. Let's hope this batch lasts a bit longer! Unlike the last set, this set has a higher reduction ratio of 663:1 instead of 362:1. This means it starts turning 0.46V (!) drawing only 3.3mA (!!) It's a 3V rated motor, but our tests show that […]

Hey Everyone, Sometimes the stars align and everything goes right... however, this was not the case for our recent sales flyer. Despite our best efforts to cancel/delay/time travel, it was sent out to the local Calgary area today. While we are still honoring the sale (with an extension until April 12th while supplies last), we […]

We've finally come upon a suitable replacment for the venerable, discontinued VPM vibrating pager disk motor. Ah, it was a splendid device, but it sure was easy to break those motor leads... Ah! But the new VPM2 has wires prebonded to the motor, and it's slightly smaller too! We welcome our new vibrating disk motor […]