Oomlout - Solarbotics Edition!

Dave Hrynkiw
November 2, 2009

Oomlout Project CIRC-02 in actionGood news, good news! We've been following the Oomlout system of learning Arduino since last February, and we've finally finished putting together our own Solarbotics Edition of the open-source ARDX Arduino Experimenter's Kit.

Besides just working with the fine folks at Oomlout to make sure our edition meets their high standards, we've also been contributing our own efforts to the documentation sideof the project. Open-source collaboration works!

So what's different about the Solarbotics edition of the ARDX?

  • 12 colour breadboard template overlay sheets. These make it particularly easy to accurately mount your parts to the breadboard.
  • The 5-cell AA battery pack holder. 7.5V means the 5V power regulator on your Arduino / Freeduino-SB will run perfectly with no fear of a voltage sag.
  • Large 11 x 7" plastic case has plenty of space for your whole experimenter's package - even the manual!
  • Larger-than-normal 10 x 6x3/8" 32 page manual is easier to read than a folded 8.5x5.5" half-sheet manual

The rest of the kit contains a veritable plethoria ("lots of neat things"), including:

  • Arduino Duemilanove with ATmega328
  • 300 point breadboard
  • Laser cut color acrylic base-plate
  • 1 USB A-B cable
  • 70-piece flexible jumper wire bundle (these are nice)
  • 10 x Red 5mm LEDs
  • 11 x Green 5mm LEDs
  • 1 x massive 10mm blue LED
  • 1 x DC Motor
  • 1 x Mini Servo
  • 1 x 74HC595 8-bit shift register IC
  • 1 x Piezo Speaker/sensor element
  • 2 x Pushbuttons
  • 1 x 10k Trimpot with handy finger-sized knob
  • 1 x Photo resistor
  • 1 x TMP36 Temperature sensor
  • 1 x 5V DPDT relay
  • 2 x 2n2222 transistors
  • 25 x 560 ohm resistors
  • 3 x 2.2k resistors
  • 3 x 10k resistors
  • 2 x 1N4001 diodes
  • Arduino-to-acrylic base mounting hardware
  • 4 x 2-pin male headers (for pinning the templates to the breadboard)
  • 1 x 20-pin male headers (for pinning more templates to other breadboards)

MORE POSTS

July 31, 2009
Resistance is Futile if < 1ohm

Hey, look at us! We made a witty, over-used joke! But seriously, this week we have a schwack-load of resistors for you. Normally we save most of these for our internal use, but what's so fun about that? So we've gone ahead and opened up our entire inventory of  5% accuracy, 1/4 watt resistors. There […]

November 23, 2003
GM10 Modifications

Grant has taken some time to document how to turn a standard 81:1 GM10 pager gear motor and turn it into a 9:1 version. Why would you want to do that? You tell me - I'd love to know what project you build with a speed demon like that! Read More...

September 13, 2005
Solarbotics Event Sponsorship

Brian Fields is heading up a new BEAM botting competition which Solarbotics is proud to be in association with. To borrow from the website: To enter this contest all you have to do is build the smallest robot you can in one of these three categories Turbot, Walker, or Photovore. This contest is much like […]

July 22, 2016
New Product: Microcontrollers & Ras...

SparkFun Electric Imp Breakout $17.48 The SparkFun Electric Imp breakout board makes it easy to experiment with your Electric Imp IoT project. ESP-12F AP+STA Remote Serial Port WIFI Controller / Module $9.38 The ESP8266 (ESP-12F AP+STA) is a nice "Internet of Things" microcontroller with Wifi (or as a Wifi bridge for your project) Adafruit Metro […]

Solarbotics Ltd Logo
Solarbotics has been operating for more than 25 years, bringing electronics know-how and supplies to both the electronics professional and hobbyist. We'll be happy to help you too!

Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.

Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.

cart