Fun fact: Tomorrow is Good Friday. By default, that means for the other 51 weeks of the year we experience Bad Fridays. We're not quite sure what exactly makes them so undesirable per se, but because the chance to celebrate a Good Friday comes around so infrequently, we've got to act on it, dangit. So […]
Heated Car Seat Teardown and Repair
Solarbotics Ltd
January 11, 2017
Here's a little makeover of an inexpensive aftermarket heated car seat heating pad that stopped working.
Designed to activate and warm up when sat upon, the electronics face a fair amount of abuse: since the seat is a soft frame, the wires inside constantly move and flex with the body. They are also subject to harsh temperature changes with frequent (very) cold weather heating and cooling cycles, adding to a situation ripe for a malfunction, which happened to one of our staff when he couldn't warm up his tush one cold Canadian morning...
Dragging it into the lab, we peeled back the covers to discover the usual and not-so-usual suspects.
Broken wires:
The old wires had a PVC jacket that had dried out and cracked.
The wires would then flex at these cracks and break:
We replaced those wires with our GroovyNoodle silicone wire, which is able to resist flexing and temperature fluctuations very well.
Sketchy Safety?
Here's a picture of the sketchy activation switch we found inside the bottom part of the seat. It's designed to close when under "bum load", and directly pass power to the heating coils. We're not experts at auto-grade accessory manufacturing, but we were surprised that it wasn't a logic "bum-detected" switch that triggered a suitable relay or FET elsewhere. And the lack of a thermal reset fuse surprised us.
Repaired
All broken wires replaced! Almost all the PVC jacket wire had cracked and disintegrated, so we replaced it with our better-quality GroovyNoodle silicone wire. This wire is extremely flexible, high strand count, and a temperature-ignoring silicon jacket. Perfect for inside this car seat heater.
All necessary repairs and upgrades were done just in time for the next stretch of (very much) cold Canadian winter.
MORE POSTS
Solarbotics WCRG mini-sumo workshop
The night before WCRG, and all through the office, not a creature was stirring...except two dozen mini-sumo robots - AAAHH! Thanks to Alberta Printed Circuits, we were able to sponsor a mini-sumo workshop to build 24 robots to compete in the next day's Western Canadian Robot Games.
Rick and Morty Portal Gun
Every year a group of my friends have an engineering Secret Santa. The rules are simple: make something cool for under $20 that requires engineering to complete. In years past we’ve seen Google cardboard VR headsets that are 6DOF, match stick rockets, 3D printed fans that explode when used, 3D printed rockets with cardboard launch […]
Solarbotics looking for fun people
...oh, and they also should want to work with us. We have a few positions open we want to fill with people that have a good sense of humour, have some geek qualities, and can tell the difference between a diode and resistor (or sincerely want to learn!) Here are the types of people we're […]
Solarbotics has been operating for more than 25 years, bringing electronics know-how and supplies to both the electronics professional and hobbyist. We'll be happy to help you too!
Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.
Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.