Friday New Product: Motor Brackets, Mini...

Solar botics
May 3, 2013

And again, after a little bit of a (long) break, we're back with the new exciting things. This time we brought in some tiny motor brackets, a Minishield from Didel and a uM-FPU64 Breakout Board Kit.

GM23 Motor Brackets & 18mm Wheels
$13.52
The microbot revolution has arrived! These brackets and 32mm wheels are much needed accessories to make great use of the tiny GM23 Gear Motor.
GM23 Motor Brackets & 32mm Wheels
$14.56
The microbot revolution has arrived! These brackets and 32mm wheels are much needed accessories to make great use of the tiny GM23 Gear Motor.
Didel 2 Motor Minishield
$17.16
Need a Motor driver that can run at the lower voltages? The Didel 2 Motor Minishield can come to your rescue! Use your Arduino Uno (or form factor compatible) board with it to drive a tiny robot around.
uM-FPU64 Breakout Board Kit
$33.95
The uM-FPU64 28-pin breakout board has all of the required connections, and provides access to all uM-FPU64 pins. It can be used itself for permanently mounting in a project or to compliment another development board.

Ok, this is gonna be a very short conclusion this time. Hmmmm, what's the good excuse to run off? Oh, the weather is really good! And I promised our lasers a nice long walk!  So I gotta take them out, all three, on a leash,  see you next ti...

MORE POSTS

August 21, 2015
Friday New Product: Grove, Kossel and XB...

Seeed Raspberry Pi Breakout Board v1.0 $14.95 The Raspberry Pi Breakout Board for Raspberry Pi is a prototype board that allows you to combine your Raspberry Pi with other components and modules. Grove - Light Sensor(P) $3.75 Panel mount light sensor from SeeedStudio. XBee WiFi Module - Wire Antenna $52.75 This is the XBee WiFi […]

November 28, 2006
Herbie the Mousebot and Photopopper 5.0 ...

After another marathon documentation-writing session, we're proud to announce that both "Herbie the Mousebot" and the "Photopopper 5.0" are in full production! Just in time for Christmas!

October 20, 2011
The Many Faces of SAFE

The SAFE (Solarbotics Arduino Freeduino Enclosure) is a marvelous contraption of laser-cut acrylic that makes a complete enclosure for your Arduino project. It gives you a protective shell with enough room for a basic shield, with knock-outs for power and USB connection. It even has a power switch. The big problem with Arduinos and Freeduinos, […]

July 31, 2009
Resistance is Futile if < 1ohm

Hey, look at us! We made a witty, over-used joke! But seriously, this week we have a schwack-load of resistors for you. Normally we save most of these for our internal use, but what's so fun about that? So we've gone ahead and opened up our entire inventory of  5% accuracy, 1/4 watt resistors. There […]

1 76 77 78 79 80 253
Solarbotics Ltd Logo
Solarbotics has been operating for more than 25 years, bringing electronics know-how and supplies to both the electronics professional and hobbyist. We'll be happy to help you too!

Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.

Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.