Just tripped over this link on the Yahoogroups BEAM mailing list. Nice looking walker - built using our BEP boards too!
A handy tutorial explaining how to put together the RGB LED Horns. Make your own, or get a kit with everything included (except for the paint).
Supplies:
Fosshape 300
2 x slow scroll RGB LED
2 x coin cell batteries
conductive thread
2 x coin cell battery holder - sewable
2 x pieces of velcro (hook side)
dimensional fabric paint (like this) - not included in the kit
Tools:
scissors
needle
heat gun
needlenose pliers
clear nail polish - optional
Step 1. PatternCut out your own pattern - a simple triangle and a circle for the base.
Step 2. Shape the hornSew the triangle along the long edge. Shrink and form it over the heat gun - make sure to watch the fabric, when heated too much it will melt and form holes. Instead of trying to form the hot Fosshape with your hands, the best way to harden the shape is to hold it above the heat gun making sure to heat it evenly and let it shrink. Shrink the bases too while keeping them flat, but don't sew them on yet.
Step 3. LEDs preparationWith needlenose pliers curl up the LED legs and bend them 90 degrees so that the loops sit flat when the LED is facing up.
Step 4. Battery holder
Grab the battery holder, a coin cell and the base and attach the LED using conductive thread. Make sure the polarity of LED and battery are correct. If everything is wired right the LED will light up.
Step 5. Sew the baseSew the base to the horn like shown and add a little tab of Fosshape and Velcro to the opposite side in order to keep it in place. Paint some clear nail polish on the bottom of the horns to isolate the conductive thread from touching the metal of the hair clip. Alternatively, you can fluff up the small scraps of Fosshape and fuse them over the stitches to protect the conductive thread.
Step 6. PaintEmbellish the horns with a pattern of your choice using the Tulip paint. It will take about 4 hours to dry. The Fosshape disperses the light quite nicely.
Step 7. Hair clipHot glue the hair clips to the bottom of each horn. Alternatively, you can sew the finished horns to hair clips or a head band.
Just tripped over this link on the Yahoogroups BEAM mailing list. Nice looking walker - built using our BEP boards too!
What's going on here? We haven't had this much new product come online so quickly since... since... well, let's just say "in quite a while!" Here's a book to add to your bookshelf: "Building Robot Drive Trains" by Clark & Owings. It's an excellent text on anything you need to know about putting power & […]
Lulzbot Mini 2 Documentation Lulzbot Mini 2 Quick Start Guide Lulzbot Mini 2 Quick Start Video How to use the LCD Interface Video How to Replace a Damaged/Bubbled PEI Sheet Video How to update your firmware Video How to use Cura: Lulzbot Edition Software Video (slightly outdated but relevant) Lulzbot Mini 2 Detailed Calibration and […]
It's once again Friday, and you know what that means - new stuff! And, on this particular Friday in Calgary "Cowboyland" Alberta, it's the start of the 100th Calgary Stampede. This is a pretty big deal, or so we hear, judging from the rampant "yee-haws" that are shouted into the July air with surprising frequency […]
Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.
Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.