Thanks to Bill Bigge, we've got a PDF dimension drawing of our GM10 gearmotor available for download. Thanks go out to Bill and his ruler! Read More...
A handy tutorial explaining how to put together the RGB LED Horns. Make your own, or get a kit with everything included (except for the paint).
Supplies:
Fosshape 300
2 x slow scroll RGB LED
2 x coin cell batteries
conductive thread
2 x coin cell battery holder - sewable
2 x pieces of velcro (hook side)
dimensional fabric paint (like this) - not included in the kit
Tools:
scissors
needle
heat gun
needlenose pliers
clear nail polish - optional
Step 1. PatternCut out your own pattern - a simple triangle and a circle for the base.
Step 2. Shape the hornSew the triangle along the long edge. Shrink and form it over the heat gun - make sure to watch the fabric, when heated too much it will melt and form holes. Instead of trying to form the hot Fosshape with your hands, the best way to harden the shape is to hold it above the heat gun making sure to heat it evenly and let it shrink. Shrink the bases too while keeping them flat, but don't sew them on yet.
Step 3. LEDs preparationWith needlenose pliers curl up the LED legs and bend them 90 degrees so that the loops sit flat when the LED is facing up.
Step 4. Battery holder
Grab the battery holder, a coin cell and the base and attach the LED using conductive thread. Make sure the polarity of LED and battery are correct. If everything is wired right the LED will light up.
Step 5. Sew the baseSew the base to the horn like shown and add a little tab of Fosshape and Velcro to the opposite side in order to keep it in place. Paint some clear nail polish on the bottom of the horns to isolate the conductive thread from touching the metal of the hair clip. Alternatively, you can fluff up the small scraps of Fosshape and fuse them over the stitches to protect the conductive thread.
Step 6. PaintEmbellish the horns with a pattern of your choice using the Tulip paint. It will take about 4 hours to dry. The Fosshape disperses the light quite nicely.
Step 7. Hair clipHot glue the hair clips to the bottom of each horn. Alternatively, you can sew the finished horns to hair clips or a head band.
Thanks to Bill Bigge, we've got a PDF dimension drawing of our GM10 gearmotor available for download. Thanks go out to Bill and his ruler! Read More...
ArtBots 2008 was held on September 19-21 in the Science Gallery at the Trinity College in Dublin, Ireland. The show featured 15 works of art by 16 artists from 9 countries. Solarbotics Ltd was proud to provide several demo robots to the Science Gallery to use during ArtBots for their “hands-on” robot display. One of […]
Update: Additional information from the Loveland Reporter Herald We've been big fans of Aleph Objects' 3D printers. They fit that sorta "Prosumer" niche. A bit better than kit-builds, not quite as expensive as the big professional units. We were disappointed we got the call a few months ago relating that Aleph was looking to shut […]
We've got two pairs of weekend passes for the Calgary Mini Maker Faire taking place this weekend up for grabs. To enter, send an email to it@solarbotics.com with the subject of "I <3 Solarbotics" to enter. Two winners will be selected Friday the 13th @ Noon.
Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.
Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.