I've got a note on my desk that says "Annouce that some Canadian Prices have changed". Uh...ok. I do what I'm told. Apparently, this has something to do with our Canadian dollar climbing like a rabid beaver.
You want a simple Photovore? This very tidy design by Solarbotics' own Grant McKee is based on a technique developed by Mark Tilden - Shok architecture:
Here's video of the test robots being tuned as a 177kB Windows Media Format (WMV) file or as a 168kB RealMedia (RM) file.
ShokPopper V1.0 (click for circuit diagram) - GrantM Aug 2001
Theory of operation:
"Shok" architecture is a technique pioneered by Mark Tilden describing controlled state changes of Bicore style circuits via chip power or enable toggling. When a Bicore circuit is powered on, it will resume a state opposite to what it was when it was powered off, this effect can either be duplicated by pulsing the enable line or by pulsing power to the chip itself. This is called "shoking" the Bicore. The power-on state can also be pre-determined by biasing the voltage across the Bicore capacitors. A photodiode attached directly across the Bicore charge capacitor will pre-bias the shoked output. The addition of tactile sensors is easily implemented by attaching a switch from the input of the Bicore to +Vdd. When the switch is closed, it forces that side high, presetting the state of the Bicore on the next pulse cycle.
Probably one of the simplest photovore circuits to date, the core circuit consists of a 6 part count and a solar-engine. Either 74AC240 or 74HCT240 will work but we recommend using the AC series for better output drive current. The ShokPopper will not work under battery power unless the enable line is pulsed.
Solar Engine to use with Shok:
The best solar-engine to use is the Miller engine. For the ShokPopper Photovore we used a Miller engine consisting of:
The Bicore Circuit Consists of:
The Miller engine switches the ground line of the circuit.
The theory of operating is very similar to that of the shok popper except that the head now only uses one motor, the photo head does not "lock" on but will continually seek for the brightest source of light. Nice effect if you want a continually seeking, dynamic device on a stationary base.
I've got a note on my desk that says "Annouce that some Canadian Prices have changed". Uh...ok. I do what I'm told. Apparently, this has something to do with our Canadian dollar climbing like a rabid beaver.
It's another Friday and we are back with the product that makes sense - it is metric! It is not measured in twips, poppyseeds, barleycorns, yards, furlongs, or any of this funny stuff. It's your good old straightforward decimals. Metric 2.5mm Hex Nut - 25 Pack $4.00 Metric M2.5 Hex Nut, in packs of 25, […]
Remember the other week when we mentioned how the Arduino Parts category was looking rather thin? Well, we've gone ahead and fattened it up a bit with the following new items: 16MHz Through-Hole Crystal for Arduino Ardubot Bare PCB Barrel Power Jack 2.1mm Connection You might be wondering what the heck does a power jack […]
We're still undergoing website bug-stomping. You may have noticed some changed news items and the like. One of the edits crashed the page, so we had to reload an older backup. The SCPD photodiodes are now officially sold out! KaPUT! Gone! Until we can find a reasonably priced replacement, we won't be restocking these items […]
Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.
Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.