Hi!
Grrr... Time to start handing out the 1000 lashes with a wet noodle. There's a few pricing errors in the new catalog 6:
Sorry about the confusion, folks. I wish we could afford to honour the under-pricing and correct just the over-pricing, but we have a staff to feed and free community servers (www.solarbotics.net) to support!
Brainwave Pro 3-Axis CNC controller For Kossel $185.83 The Kossel Pro uses the Z-Designs Brainwave Pro controller, which is the product of a close collaboration between Terence Tam and Mike Ziomkowski, based upon Matthew Wilson's original Brainwave low cost 3D Printer controller. Kossel Ball Joint Set Kit $78.00 These are not repurposed RC Car ball […]
New products added to our inventory include the L293D motor driver IC (a staple chip used in small-robot building), and the new clear-case GM4 servo gearmotor! No electronics, just a full 360° rotating, strong, modified servo! Check out the "New Products" link on the left toolbar for pricing and details.
Grove - 4 pin Female Jumper to Grove 4 pin Conversion Cable (5 PCs per Pack) $4.95 4 Pin jumper wire for easy Grove-to-Arduino connections. Infrared LED Emitter $0.50 Standard sized T1-3/4 infrared emitting LED. Raspberry Pi Relay Board v1.0 $29.40 The Relay Shield contains four high quality relays and provides NO/NC connections to control […]
Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.
Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.