Grant has taken some time to document how to turn a standard 81:1 GM10 pager gear motor and turn it into a 9:1 version. Why would you want to do that? You tell me - I'd love to know what project you build with a speed demon like that! Read More...
The instructions for assembling the Pi v3 and the previous acrylic Pi SAFE are quite similar. The only difference between the models is the location of the LED light pipes, so these Pi3 instructions apply generally to all Pi SAFE versions.
Find 4 of the 4-40 x 3/8" bolts, and put them through the baseplate, and press the spacers on from the other side. Thee bolts will sort of stay put until you can get the Raspberry Pi on the baseplate. (If adding to a VESA mount, do only 2 diagonal screws)
Slide the Raspberry Pi onto the bolts. The Pi is designed for metric M3 hardware, but we're still using imperial #4 hardware, which is a smidge bigger. The bolts may need to be screwed through the holes in the Pi.
Add the #4 nuts, and tighten them down.
Arrange the sides as shows. The sideplate on the top in this image has the long cutout to accommodate a ribbon cable from the 40-pin expansion port. The front faceplate on the right (with the label engravings face-down) is for the communications side. The sideplate on the bottom has the ports for the power, video, and audio I/O.
Align them all up on the baseplate, and use a pair of 4-40 nuts and bolts to lock them in place.
Lay the final side faceplate face-down beside the assembly, and pop the clear lightpipe parts out of their holder. It is not necessary to strip the paper off this part.
Sandwich the two lightpipes together, and push them into the lightpipe indicator hole. They will sit a bit loose until the faceplate is attached to the baseplate.
Carefully assemble this assembly to the baseplate, and finish attaching it with the remaining 4-40 nuts and bolts.
Notch the top plate into the slots in the rear faceplate, and gently flex the frontplate out to let the tab snap into place. You're ready to power up, with full access to the indication LEDs on the Pi mainboard via the lightpipes!
.
Grant has taken some time to document how to turn a standard 81:1 GM10 pager gear motor and turn it into a 9:1 version. Why would you want to do that? You tell me - I'd love to know what project you build with a speed demon like that! Read More...
We like to have some play time at Solarbotics, and the "Bare Bones Photovore" is the results of one of these play sessions. It's a very simple (amongst the simplest, we'll hazard to say) light-seeking solar-powered robot, and find it easy to build using the Bicore Experimenter's PCB.
We've received word from Dave down in San Francisco that the events are now over and that both Grant and Dave of Solarbotics have placed second and third in the mini-sumo competition!!! We would like to send our congratulations to them, and also to sneak some product out the door while they're still away and […]
Grant and I have been back from PDXBot a few weeks now, and I put together a wee movie showing off some of the (limited) video I shot. You get to see Grant winning 2nd place in Mini-sumo, me NOT using a camera correctly (I got record on/off reversed during a Grant/me match), and some […]
Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.
Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.