Just another quick note that Solarbotics will be closed for Victoria Day, Monday May 23. Any orders received after 2pm today will not go out until we open back up on Tuesday the 24th.
I created this choker as a project to demonstrate the new MicroNova APA102-2020 LED strips.
Photo by Yeti, edited by Batgirl
These addressable LEDs are extremely small, less than 1/4 the size of a standard 5050 LED.
This project was built using engineering sample standard MicroNova 99 LED / meter strips . The MicroNova strips we are selling have 198/meter - twice the density!
Hats have been done, shoes have been done, pendants have been done. This is something new for a Valentine’s dance costume, so I decided to go with a choker design. I also wanted something that was interactive, something that would add another layer of WOW to just lighting.
I used a Wemos D1 Mini development board along with a boost-converting battery shield for the Wemos D1.
The battery shield was a particularly good choice here because the MicroNova LEDs should be supplied a solid 5VDC. This board boosts the battery voltage to 5V, and then the Wemos D1 Mini bucks it down to 3V3 for it's own operation.
A mini SPDT Slide switch toggles the power from the battery shield to the D1. This allows charging the battery using the battery shield USB connector while not powering the D1.
Epoxy locks the switch and wires in place.
The battery used is a conveniently handy older 450mAh Lithium Polymer. Depending on the lighting mode, this battery can power the necklace for a couple of hours.
I used elastic thread to attach the LED strip and components to the necklace. A heavy duty needle was all that was needed to punch through the (imitation) leather belt. Because the thread was elastic and tied under tension, it held the MicroNova strip well in place.
When the choker powers up, it creates a WiFi Access Point called "HeartBurnChoker1".
Once I connected to this WiFi, I opened a browser and went to 192.168.4.1. The control interface is simple, but effective. The D1 Mini has more than ample power and speed to effectively drive these LEDs. The MicroNova features separate clock & data lines, so even relatively slow I/O (like Raspberry Pi) can still make it work.
Just another quick note that Solarbotics will be closed for Victoria Day, Monday May 23. Any orders received after 2pm today will not go out until we open back up on Tuesday the 24th.
Since Halloween is just around the corner we've built and published a few projects in order to give some ideas to the DIY costume-inclined folks. One is DIY Halloween RGB LED Kitty Ears and two is Halloween LED Witch Hat. So for this third hack we started with an online-bought robot costume, but being a […]
The following instructions detail how to build a simple pummer using a BC2 (Bicore) BEP (Bicore Experimenter PCB). A pummer is a solar powered self activating LED flasher. The difference between a pummer and a BLFNAR (blinky light for no apparent reason) is that a pummer has a soft turn off, which means that it turns on fast, but slowly fades away.
Hello, everyone! ... And without further ado, ladies and gentlemen, we present: THE BRUTUSBOT. /cue the fanfare of one thousand trumpets, a legion of marching drummers, seven tubas, and some guy named Donald busting out a wicked solo on a mandolin "Hark! What is this overwhelming contraption of might and thunderous presence?!", you must be […]
Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.
Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.