Here's a little something from Grant in the development lab - a very simple pair of circuits based on Mark Tilden's Bicore Shok architecture. This circuit makes for a very simple, effective Photovore robots, or even a photo-head. Take a look - schematics & parts listed included! We've also added a gallery entry for these […]
3D Printed Treetop Star
Solar botics
December 9, 2014
Initially inspired by the Moravian Star on Instructables and the fact that we now carry all kinds of 3D printing filament, we decided to make one of our own glowy holiday star. We have used this thing as source files to create a similar treetop decoration of our own.
After some trial and error (due to the Slicer not cooperating)...
...we printed a whole forest of perfect wintery spiky star-ends.
And, well, we just had to have someone live there for a bit. In this case, a snowman:
Our addressable 5mm LEDs were well suited to light this contraption. We drilled a hole in the bottom of each spike..
..to fit the LED's domed part:
And then wired everything up. It wasn't pretty but the WS2812 LED that we used made it much easier than a conventional RGB LED: rather than 3 separate channels, the WS2812 LED only has a data in and data out. Chain them all together and they work like a charm!
And here's the final product, ready to light up our office with wonderful glowing lights!
MORE POSTS
New Kit!The Hex Pummer
View our newest kit we have online, the Hex Pummer, a very amusing night display that is charged by the sun. When the lights go out, it triggers the high intensity LEDs to start flashing on and off. They start out very STRONG and then fade away until the next LED "PUMMS" on. These amusing […]
Friday New Product: LilyTwinkle, Teensy ...
It's Friday again, and it's been a busy (two) weeks since there was a new product. Wait no more, here it is. 4-Conductor LED Strip Clamp $0.95 Reduce the crazy soldering mess with these super useful RGB LED strip clamps! LilyTwinkle ATtiny85 $6.95 A preprogrammed controller board that can make your wearable project sparkle and […]
Oomlout - Solarbotics Edition!
Good news, good news! We've been following the Oomlout system of learning Arduino since last February, and we've finally finished putting together our own Solarbotics Edition of the open-source ARDX Arduino Experimenter's Kit. Besides just working with the fine folks at Oomlout to make sure our edition meets their high standards, we've also been contributing […]
Solarbotics has been operating for more than 25 years, bringing electronics know-how and supplies to both the electronics professional and hobbyist. We'll be happy to help you too!
Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.
Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.