16-Channel 12-bit PWM/Servo Driver - I2C interface - PCA9685

USD $14.95

It's a clever breakout board for a chip that talks I2C to drive 16 channels of PWM / Servos.

In stock

SKU: 19000 Categories: , , Tag:
DESCRIPTION
RESOURCES
MORE INFO
REVIEWS

DESCRIPTION

You would figure that creating simple on/off pulses is a pretty easy thing. Well it is. Watch: On....off.....On.....On..(DANG). Ok, it's pretty simple for a single signal, but if you're wanting to create a bunch of well-timed on/off signals, that gets particularly tricky, even for an Arduino.

Enter the PCA9685, and its breakout board from Adafruit.

Instead of using up your limited number of PWM lines, or trying to fake it all in software (and using up all the resources on your microcontroller), you can simply pop a signal over to this chip via I2C to tell it which of 16 lines you want to pulse, with 12-bit (4096) levels of accuracy. And it'll keep doing it, all by itself. Pretty handy. And the PCA9685 can be chained 62 deep, for a total number of control of 992 PWM output lines - that's impressive!

The kit comes mostly assembled, with a set of 3x4 headers for installation of servo/LED plugs, a 2-pin power terminal block, and a 6-pin 0.1" header for breadboard-compatibility.

Features

  • Power input via terminal block or 0.1" spaced pins
  • Terminal block has reverse-polarity power input protection
  • Green power LED
  • 3-pin connectors in groups of four for easy 16-servo installations
  • Easy chaining of boards
  • Power filtration capacitor installation pads
  • 220Ohm output line projection resistors
  • Solder pad jumpers for address selection

Specifications

  • 5V compliant, and still talks to a 3.3V microcontroller.
  • 6 "address select" pins for configuring up to 62 ICs on a single I2C bus
  • PWM frequency adjustable up to approximately 1.6kHz
  • 12-bit frequency resolution (equates to about 4µs resolution at 60Hz refresh rate)
  • Configurable as push-pull or open-drain output
  • Output enable pin available for outside-the-microcontroller "shut it down!" control.

Dimensions

  • No headers or terminal block) 2.5" x 1" x 0.1" (62.5mm x 25.4mm x 3mm)
  • Weight (no headers or terminal block): 5.5g
  • Weight (with 3x4 headers & terminal block): 9g

This product comes with a fully tested and assembled breakout as well as 4 pieces of 3x4 male straight header (for servo/LED plugs), a 2-pin terminal block (for power) and a piece of 6-pin 0.1" header (to plug into a breadboard). A little light soldering will be required to assemble and customize the board by attaching the desired headers but it is a 15 minute task that even a beginner can do.

RESOURCES & DOWNLOADS

Additional information

Weight 0.0105 kg
Dimensions 7.1 × 6.2 × 1.1 cm
Type

Motors

REVIEWS

Solarbotics Ltd Logo
Solarbotics has been operating for more than 25 years, bringing electronics know-how and supplies to both the electronics professional and hobbyist. We'll be happy to help you too!

Solarbotics, Ltd. is not responsible for misprints or errors on product prices or information. For more information, please see our Terms and Conditions.

Warning: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Please visit www.P65Warnings.ca.gov for more information. This item was manufactured prior to August 31, 2018.

Copyright © 2024 Solarbotics Ltd. All Rights Reserved
cart