Solarbotics


Show: Items

Sort By:


172 Products Found


39270

Solarbotics Synapse SMA X-Change Bundle

Want to try out a Synapse SNAP network where you have an Xbee network? Assemble this bundle and x-change your pre-existing Xbee hardware with this drop-in replacement.

$33.52 USD

39275

Solarbotics Synapse RF200P81 Coordinator Bundle

Synapse SNAP modules are super-useful, and here's a bundle to get a PC base-station up and running!

$59.13 USD

39280

Solarbotics Synapse RF200P81 Snap X-Change Bundle

Want to try out a Synapse SNAP network where you have an Xbee network? Assemble this bundle and x-change your pre-existing Xbee hardware with this drop in replacement.

$35.40 USD

39285

Solarbotics Synapse RF200P81 Coordinator Bundle

Synapse SNAP units also make great PC-to-network node interfaces. Here's a bundle to get you started!

$53.73 USD

22090

VS-19 Pico Linear Servo

The VS-19 Pico Linear Servo is a tiny linear actuator with 2cm of travel. The uses for this linear motor are endless, we'll leave it to you to find a killer application for it.

$9.85 USD

GM25

120:1 Micro Pager Planetary Gearmotor

This is the tiniest gear motor we've seen that's humanly affordable. What can you do with it? Ummm...

$14.50 USD

60127

Brutusbot Armor Enhancement Kit

The Brutusbot Armor Enhancement Kit is the perfect way to present your Brutusbot project. Not only is it a good way to make your bot look quite attractive but it protects the electronics as well from unfortunate mishaps like rollovers!

$9.85 USD

Make28SP

Make Solar Pendulum Bundle

Based on the project in our book "Junkbots...", it's been re-featured in Make Magazine Volume 28 as a DIY article!

$15.80 USD

60135

DragonTail Electronics Bundle

Our DragonTail is a brand new, bare-bones robotic platform. It's shiny and slick lookin', but... What can you do with it? Here is a bundle to get the DragonTail navigating its environment in no time!

$63.50 USD

GM23

Gear Motor 23 - 1:192 Offset Shaft

This 1:192 Tiny Geared Pager Motor has an offset shaft much like the GM2, but is roughly half the size in every dimension. We suspect that these were the motors used for the Magic school bus in it's miniature state.

$5.00 USD

GM24

Gear Motor 24 - 1:192 90 Degree Shaft

Call it a teeny, tiny little brother to the GM3 gearbox. With a suitably smaller appetite for power!

$4.25 USD

LSB

Pocket Marquee Bundle

Here is a Pocket Marquee Bundle for setting up your own portable sign or displays. Design your own animations/messages and show them off wherever you go.

$42.75 USD

K SV-SS

SumoShield Sumovore Brainboard Kit

Some days at Solarbotics we like to look at the world upside down. We get on our hands and knees and try to do a headstand and pretend to walk on the ceiling. The sumoshield was created on one of these days.

$9.85 USD

17700

5mm Water-clear Phototransistor

This 5mm Water-clear Phototransistor will pick up visible and infrared light and conduct current. When light reaches this high sensitive/fast response time component it's much like current reaching the base of a transistor which allows current to flow from collector to emitter.

$0.45 USD

BASS

Arduino Sumovore Bundle

Throw this bundle together to have one of the first Arduino-compatible Mini-Sumo kits out there. Get your trusty soldering iron out, build the Sumovore and Sumoshield Kits, then toss the Arduino on top, program it with the supplied code, and watch the Sumo/Line-following madness ensue.

$125.95 USD

45075

Sharp Sensor Cable, 20cm

You'll save tons of time and won't need the soldering iron for these Sharp infrared sensor cables! These cables allow you to easily interface Sharp infrared sensors to your robotics project without the need for soldering.

$1.95 USD

14183

JST-PH-2.0 2-Pin Connector Plug w/ Wire

A dramatic tale of two wires. One red. One black. Joined by a single female JST connector. Of destiny.

$1.29 USD

14185

JST-GH-1.25mm 3-Pin Wired Header w/ Plug

The really tiny connectors (not to be confused with the just tiny connectors) that are used on many... tiny things. You'll know them when you see them!

$1.49 USD

60103

Solarbotics Raspberry Pi V1 SAFE

Raspberry Pi Version1 protective case kit, in acrylic.

$8.95 USD

60095

Solarbotics SAFE VESA Mount Add-on

The Pi SAFE VESA mount is a convenient way to attach your Pi to the back of your monitor or TV.

$3.00 USD

K JB

Solarbotics BeetleBot

The BeetleBot is a simple kit to make a quick and basic obstacle-avoiding robot without using any solder.

$34.95 USD

ARDX-BK

ARDX Acrylic Base Kit

Wrangle in your loose Arduino - you don't want them going rogue, so tie it down to an ARDX experimenter's platform!

$6.95 USD

Currency


Login

Email:

Password:

Remember Me

Forgot Your Password?

Don't Have an Account?
Sign Up!