» Motors & Servos » Standard Motors
This Nema 17 Stepper motor offers substantial holding torque at a low 2.8VDC. It's the same model as used in the Openbeam Kossel 3D printer.
The VPM2 is a replacement for the now unavailable venerable VPM. At 12mm dia x 3.4mm thick, it's smaller than the original, and has presoldered leads!
This motor is a larger NEMA-17 motor that produces a whopping 4800g-cm of holding torque.
These new, factory-fresh pager motors come ready-to-run: no eccentric weight removal necessary like on surplus pager motors!
This "030" form factor motor replaces the old Mabuchi FF-030 we used to stock, and is still a good candidate for torquey Solarengine and small battery-powered robots.
Need more power out of your gear motor? This is a high-power motor that fits in the same form factor as used by the GM2/3/8/9 style gear motors.
This is the standard motor that is built in to the GM2/3/8/9. Nominally runs at 6VDC and consumes roughly 35mA
This surplus wheel set comes with one motor, two sets of wheels (two standard, two wide plastic studded tires and plastic hubs) and four guide rollers.
This motor is about half as small as our NEMA-17 Stepper and as a result only needs about half the power. Compared to the other NEMA-14 stepper we carry, it's a little longer but has the option to mount an encoder to the rear shaft!
The RF500TB is a very efficient, powerful, slow pancake motor.
Forgot Your Password?
Don't Have an Account?Sign Up!