Components


Show: Items

Sort By:


380 Products Found


DZ3.4

3.4V Zener Diode

This unit has a minimum voltage of 3.315 V and a maximum voltage of 3.465 V, a leakage current of 1 V and a test current of 76 mA.

$0.50 USD

DZ5.1

5.1V Zener Diode

This unit has a minimum voltage of 4.845 V and a maximum voltage of 5.355 V, with a leakage current of 1 V and a test current of 49 mA.

$0.50 USD

RT10K-T

10k Single-Turn Trimpot, w/ Knob

Handy single-turn 10k trimpot with friendly knob is prototyping friendly!

$2.35 USD

RT1K-T

1k Single-Turn Trimpot with Knob

Handy single-turn 1k trimpot with friendly knob is prototyping friendly!

$2.35 USD

74HC595

74HC595 8-Bit Serial to Serial/Parallel IC

The 74HC595 is very useful in expanding how many pins a microcontroller can write to. Use 3 to write to 8!

$0.95 USD

50838

LilyPad Slide Switch

This is a simple slide switch for the LilyPad. Use it as a simple ON/OFF switch, or to control LEDs, buzzers, sensors, etc.

$3.95 USD

14052

I2C-It Y-Cable Harness set

The I2C-It is a great sensor, and is only more so when used as part of a greater chain. Use the I2C-It Cable harness and pin set to set up multiple sensors!

$2.84 USD

40253

BittyBot 3-Way Object Sensor

Left, Middle, Right short range sensors in a small package.

$30.00 USD

40256

BittyBot Micro Line Sensor Kit

The Bittybot Micro Line sensor is a convenient way to build edge or line sensors, especially for MicroSumos!

$12.31 USD

40254

BittyBot Nano Line Sensor Kit

BittyBot's Nano line sensor kit is a tight and tidy .95" wide pair of sensors for detecting white/black differences, like a line on a surface. Ideal for line-followers or sumo edge detection!

$12.31 USD

40250

BittyBot ProxDots (2-pack) Kit

Looking for tiny proximity sensors? The BittyBot Proxdots are very small, and complete with IR modulated transmitter /receivers!

$14.21 USD

40251

BittyBot ProxDots (4-pack) Kit

Looking for tiny proximity sensors? The BittyBot ProxDots are very small, and complete with IR modulated transmitter / receivers!

$22.31 USD

50510

FTDI Basic Breakout (3.3V)

This is the SparkFun basic breakout board for the FTDI FT232RL USB to serial IC. The pinout of this board matches the FTDI cable to work with official Arduino and compatible (like the Freeduino SB) boards. 3.3V version.

$13.95 USD

50512

FTDI Basic Breakout (5V)

This is a basic breakout board for the FTDI FT232RL USB to serial IC. The pinout of this board matches the FTDI cable to work with official Arduino and cloned 5V Arduino boards.

$14.95 USD

UBLED10

Ultra Bright 10mm LED

These 10mm LEDs are big and bright.

$1.00 USD

SBLED

Super Bright 5mm LED

Our SBLED series of LEDs are designed to throw light out to the side of the lens for a wide light dispersal pattern.

$0.85 USD

14150

Phidgets Sensor Cable 60

Use this 60cm/24" sensor cable to plug in your Phidgets sensor to the Interface Kit 8/8/8.

$2.00 USD

35194

QTI Sensor

When the QTI sensor is over a dark surface, the reflectivity is very low; when the QTI is over a light surface, the reflectivity is very high and will cause a different reading from the sensor.

$9.99 USD

BAMPPK

The Mighty Mini Bundle

The Mighty Mini Bundle is basically an Arduino in its prime that has exercised... a lot! Not only is it skinny but it has the rated regulated power of 5 ordinary Arduinos (5 Amps) to back it up.

$31.00 USD

17185

LM1084 5V 5A LDO Voltage Regulator

The LM1084IT-5.0 is a beast of a +5V voltage regulator! Spawning from the same family as the LM317 (sharing the same pinout), this regulator takes current limitations to a whole new level. Perfect for powering servos and handling the load they generate up to 5A!

$3.55 USD

14190

10 and 6-pin AVR Programming Cable

This is a handy AVR programming cable that incorporates both the 10-pin and 6-pin ISP programming interfaces.

$1.95 USD

15009

12" Servo Extension Cable - Male / Female

Universal connectors fit both Futaba and Hi-Tec/JR(S). Male to female. Very flexible, 12" long 22 AWG stranded wire. Black, red, white silicone rubber insulation.

$3.99 USD

15005

14" 3-Conductor Extension Cable

The 14" 3-conductor extension cable is ideal for use with additional accessories mating with the Prop-1 and Prop-2 controllers

$2.50 USD

15010

24" Servo Extension Cable - Male / Female

Universal connectors fit both Futaba and Hi-Tec/JR(S). Male to female. Very flexible, 24" long 22 AWG stranded wire. Black, red, white silicone rubber insulation.

$4.99 USD

15011

36" Servo Extension Cable - Male / Female

Universal connectors fit both Futaba and Hi-Tec/JR(S). Male to female. Very flexible, 36" long 22 AWG stranded wire. Black, red, white silicone rubber insulation.

$5.99 USD

Currency


Login

Email:

Password:

Remember Me

Forgot Your Password?

Don't Have an Account?
Sign Up!